Changing Copy Setting on Each Job - JOB BUILD - 105
4
Select “ON”, press the [ENTER] button, and then the [CANCEL] but-
ton.
The job build function is set and the LCD screen shows as follows:
5
Place the first job of the originals.
6
Select other copy modes as required, and then press the [START]
button.
Scanning starts. When the scanning is finished, the LCD screen shows as follows:
7
Place the next job.
Repeat steps 6 and 7 until all the jobs are scanned.
8
When all the originals have been scanned, select “End job build”,
and then press the [ENTER] button.
Copying starts.
JOB BUILD
ON
OFF
1
AMS SORT
ZOOM FINISHING EDIT
READY
(JOB BUILD)
JOB BUILD
Scan next page
End job build
JOB BUILD
Scan next page
End job build
To Next Page
Loading...
