127
4
4
Press the [AUTO] button to automatically detect the appropriate eth-
ernet speed, or press other specific ethernet speed button.
• When you select a specific ethernet speed, you must select the same ethernet speed as set in the connected
network. If you do not know the ethernet speed that must be used, select the [AUTO] button.
• If the network is not stable, power OFF the equipment then ON.
5
Press the [ENTER] button.
• Returns you to the NETWORK menu.
6
Continue to another network setting if required, then press the
[APPLY NOW] button.
• The "NETWORK INITIALIZING" message is displayed and this equipment starts initializing the network inter-
face card to apply the changes.
To Next Page
Loading...
