63
2
Continuous feed mode
When the number of originals is too large to be set at one time, you can previously divide the originals into sev-
eral sets to copy them continuously. To do so, place the first set of the originals and press the [CONTINUE] but-
ton on the touch panel while the data of this set are being scanned. When this scanning has finished, set the next
set of the originals and press the [START] button on the control panel.
1
Align all the originals. Then place them
face up and align the side guides to the
original length.
• Place the originals straight along the side guides.
• Collate the originals in the order that you want them to be cop-
ied. The top sheet of the originals will be fed first.
• This mode is also available for one-sheet originals.
• Regardless of their sizes, originals are acceptable up to 100
sheets (9.3 to 20 lb.) or 0.62" in height.
• For mixed-size originals, see P.93 “Copying mixed-size origi-
nals in one go (mixed original size)”.
• Use the original stopper as required.
• To replace the original stopper, lift it slightly and push it in.
To Next Page
Loading...
Need help?
General
