74
2.HOW TO MAKE COPIES
3.Bypass Copying (Cont.)
2
Bypass copying on standard size paper
Copying on LD, LT, LG and ST-R size paper
2
Place the original(s).
3
Press the button of the same size as the one of the paper you have set
on the tray.
• If the paper size is not specified here, copying may be slowed down.
1
Place some sheets of paper with their
copy side down on the bypass tray. Align
the side guides to the paper length while
holding A.
• The message “Ready for bypass feeding” appears.
• Rear side of the side guides of the bypass tray has an indicator
for paper height. The height of the sheets must not exceed this
indicator.
• When you use more than one sheet, fan the sheets well before
setting them on the tray.
• Do not push the sheets into the entrance of the bypass feeder;
this may cause a paper jam.
When the paper size is larger, draw out the three-stage paper
holder. Raise B when you use LD or a larger size of paper.
A
B
To Next Page
Loading...
Need help?
General
