Toshiba e-Studio 202S - Page 49

e-STUDIO202S DISASSEMBLY AND ASSEMBLY 8 - 8
6) Remove the screw and remove the PPD2 sensor.
7) Remove the plate spring on the right and remove the heater
lamp.
8) When opening the fusing unit, slide the fusing lower earth
spring in the arrow direction, and open the unit.
If the fusing unit is opened without sliding the fusing lower
earth spring, the fusing lower earth spring is deformed.
If the fusing lower earth spring is once deformed, the earth
function may not work properly. Replace the deformed spring
with a new one.
9) Remove the spring, and remove the upper separation pawls (3
pcs.).
10) Remove the E-ring and remove the reverse gate.
11) Remove the spring, and remove the lower separation pawls (4
pcs.).
1)
2)
PPD2 sensor
1)
2)
Heater lamp
3)
1)
2)
2)
1)
3)
2)
2)
2)
1)
2)
08/09