.
18 (GB) Safety Information
Other points
y Do not turn the power OFF with misfed paper remaining inside the equipment.
This could cause a malfunction when the power is turned ON next time.
y Be sure to turn the power OFF when leaving the office or if there is a power outage. However,
do not turn the power OFF if the weekly timer is in use.
y Be careful because the paper exit area and paper just after exiting are hot.
y Do not place anything other than paper on the receiving tray. This could disturb a normal
operation and cause malfunctions.
y Do not touch the photoconductive drum. This could cause image problems.
y Do not open/close the covers and the bypass tray, or pull out the drawers during printing.
During maintenance or inspection
y Never attempt to repair, disassemble or modify the Multifunctional Digital Systems by
yourself. You could cause a fire or get an electric shock.
Always contact your Service representative for maintenance or repair of the internal parts of
the Multifunctional Digital Systems.
y Do not let liquids such as water and oil get into the system when cleaning the floor. This could
cause a fire and give you an electric shock.
y Always keep the plug and outlet clean. Prevent them from accumulating dust and dirt. This
could cause a fire and give you an electric shock due to the heat released by electric leakage.
Other points
y Do not use such solvents as thinner or alcohol when cleaning the surface of the
Multifunctional Digital Systems.
- This could warp the shape of the surface or leave it discolored.
- When using a chemical cleaning pad to clean it, pay attention to any cautionary points.
When handling supplies
y Never attempt to incinerate toner cartridges. Dispose of used toner cartridges in accordance
with local regulations.
Other points
y Read the operator’s manual carefully to replace the toner cartridge using the correct
procedure. An improper procedure could cause toner leakage or scattering.
y Do not open the toner cartridge forcibly. This could cause toner leakage or scattering.
e-STUDIO2802A/2802AM/2802AF e-STUDIO2309A/2809A