13
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 FUSER UNIT
13 - 15
[F] Pressure roller
(3) Remove 1 C-ring and 1 bearing from the
fuser roller front side.
(4) Remove 1 C-ring, 1 gear and 1 bearing from
the fuser roller rear side.
Fig.13-17
(1) Take off the fuser roller
(! P.13-14 "[E] Fuser roller").
(2) Place the fuser unit with the pressure roller
on its bottom. Remove 2 screws and take off
the fuser unit entrance guide.
Fig.13-18
(3) Take off the pressure roller. Remove 2 E-
rings and the bearings on both ends of the
pressure roller.
Note:
The pressure roller is quite heavy. Do not
drop the roller when lifting up.
Fig.13-19
C-ring
C-ring
Bearing
Bearing
Gear
Fuser unit entrance guide
Bearing
E-ring
Bearing
Pressure roller
E-ring
To Next Page
Loading...
