e-STUDIO2500c/3500c/3510c
(3) Enter adjustment mode [05]. Change the values for codes [2934 to 2937] to adjust the transfer (2nd
transfer) roller bias output.
(Adjust the offset voltage of transfer roller bias so as to increase the density of the image.)
• The code to use varies according to the paper type. Adjust the value for [05] code corresponding to the
paper type for which you would like to improve the image quality. Set the value within a range of "2" to
"8" to obtain the highest density of the image.
Paper type [05] code Subcode
Recommended
value
Acceptable
value range
Default
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Front
Recycled paper
05-2934
7
2 to 8 0 to 10 5
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Full color
Back
Recycled paper
05-2935
7
2 to 8 0 to 10 5
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Front
Recycled paper
05-2936
7
2 to 8 0 to 10 5
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Black
Back
Recycled paper
05-2937
7
2 to 8 0 to 10 5
* "Front" refers to the printed side in the simplex mode or the side that is delivered facing upwards in the duplex mode.
"Back" refers to the printed side that is delivered facing downwards in the duplex mode.
* The table below shows you the acceptable paper weight for the paper type.
Paper type Acceptable paper weight
Plain paper 64 to 105 g/m² 16 to 20 lb. Bond
Thick 1 106 to 163 g/m² Max. 60 lb. Cover
Thick 2 164 to 209 g/m² Max. 110 lb. Index
Thick 3 210 to 256 g/m² Max. 140 lb. Index
• After adjusting the transfer roller bias output, perform automatic calibration in the same manner as in
procedure (2).
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
1.1
To Next Page
Loading...
