e-STUDIO2500c/3500c/3510c
(1) Enter adjustment mode [05]. Change the values for codes [1613 to 1618] to adjust the amount of toner used.
• The code to use varies according to the paper type. Adjust the value for [05] code corresponding to the
paper type for which you would like to improve the image quality and increase the value to obtain the copy
density that the user desires.
Paper type [05] code Recommended value
Acceptable
value range
Default
Thick 1 05-1613 Set a value larger than 252. 252
Thick 2 05-1614 Set a value larger than 252. 252
Thick 3 05-1615 Set a value larger than 252. 252
OHP 05-1616 Set a value larger than 240. 240
SPECIAL 1 05-1617 Set a value larger than 252. 252
SPECIAL 2 05-1618 Set a value larger than 252.
0 to 255
252
* Set the value in increments of approximately 4, while checking the copy image until the optimum value is
obtained.
* The table below shows you the acceptable paper weight for the paper type.
Paper type Acceptable paper weight
Thick 1 106 to 163 g/m² Max. 60 lb. Cover
Thick 2 164 to 209 g/m² Max. 110 lb. Index
Thick 3 210 to 256 g/m² Max. 140 lb. Index
* Use the recommended OHP transparencies and special paper.
After adjusting the amount of toner used, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must use the next procedure.
(2) Perform color balance adjustment or RGB adjustment to adjust the tint of the colors in general.
* For further information regarding the adjustment procedures, refer to procedure (4) in 2.2 To Closely
Match the Color Balance of the Original.
After adjusting the tint of colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
2. Copier-specific Adjustments
2.13
To Next Page
Loading...
