3 BASIC COPY MODES
Selecting Finishing Mode 83
Selecting Finishing Mode
Finishing modes and optional finishing devices
See the table below for each finishing mode.
The available finishing modes differ depending on the type of optional finishing devices (Finisher and Hole
Punch Unit) installed. Finishing devices available for this equipment are as follows:
Finisher
y Inner Finisher MJ-1036 (for e-STUDIO2550C Series and e-STUDIO2555C/3055C/3555C)
y Saddle Stitch Finisher MJ-1037 (for e-STUDIO2550C Series)
y Finisher MJ-1107 (for e-STUDIO5055C Series)
y Saddle Stitch Finisher MJ-1108 (for e-STUDIO5055C Series)
Hole Punch Unit
y Hole Punch Unit MJ-6007 (for Inner Finisher MJ-1036)
y Hole Punch Unit MJ-6008 (for Saddle Stitch Finisher MJ-1037)
y Hole Punch Unit MJ-6104 (for Finisher MJ-1107 and Saddle Stitch Finisher MJ-1108)
Inner Tray
y Inner Tray MJ-5004 (for e-STUDIO2550C Series)
y Inner Tray MJ-5006 (for e-STUDIO5055C Series)
The inner tray cannot be installed when the Inner Finisher MJ-1036 is installed.
Finishing mode Description
Non-sort Non-staple Copies exit without being sorted or stapled.
Sort ( P.87) Copies exit in the same page order as the originals one set after
another.
Group ( P.87) Copies grouped by page exit.
Rotate sort ( P.89) Copies exit set by set alternately in a different direction.
Staple sort ( P.90) Copies exit with their corner stapled.
Magazine sort ( P.94) Copies exit in a book-type page order.
Center fold ( P.94) Copies exit in a book-type page order with their center folded.
Saddle stitch ( P.94) Copies exit in a book-type page order with their center folded and
stapled.
Magazine sort & center fold
( P. 9 4 )
Magazine sort and center fold are used together.
Magazine sort & saddle stitch
( P. 9 4 )
Magazine sort and saddle stitch are used together.
Hole punch ( P.97) Copies exit with their side punched.
Manual staple ( P.99) Copies are stapled manually.
To Next Page
Loading...
Need help?
General
