3.BASIC COPY MODES
Before Using Copying Functions 65
3 BASIC COPY MODES
Switching to the function setting menu
To change the functions on the current menu, press the corresponding buttons. The desired setting menu will
then appear.
Clearing the set functions
If you want to clear any copy function setting, press [RESET] on the corresponding setting menu.
However, for FULL IMAGE on the EDIT menu, also press the highlighted button to clear the setting.
P.113 “EDITING FUNCTIONS”
Clearing all settings changed
When you press the [FUNCTION CLEAR] button on the control panel, all the function changes will be cleared.
Even if you do not do so, the changes will be cleared if the equipment is left idle for 45 sec. (default setting).
For how to change this period, refer to the MFP Management Guide.
Restrictions on function combinations
Several copy functions can be used together. However some functions may not be used with other ones. For
details, see the following pages:
P.216 “Copying Function Combination Matrix”
P.218 “Image Adjustment Function Combination Matrix”
To Next Page
Loading...
