4.EDITING FUNCTIONS
Image Repeat 123
4 EDITING FUNCTIONS
5
Key in the read values and specify the repeat count.
1) Press [X1], [X2], [Y1] and [Y2], and then key in the read value correspondingly.
2) Change the number of times you repeat the image (repeat count) by pressing either [ 2] or [ 8].
3) Press [OK].
y The selected area will be copied from the top right corner in a vertical direction.
y If the repeated image runs over the paper size, that part will not be copied.
7
Select other copy modes as required, and then press the [START] button on the control
panel.
6
Place the original again on the original glass with its
face down.
Place with its bottom toward you. Align its top left corner against that of
the original glass.
To Next Page
Loading...
