2 HOW TO MAKE COPIES
36 Making Copies
7
Press the [START] button on the control panel.
If you did not change the number of copies in step 6 above, the number of copies printed out will be one fewer than
that previously set because you have already copied one as a proof copy. (However, if the number of copies you
previously set was 1, another set of copies will be printed out besides the proof copy.)
Selecting exit tray
You can select the exit tray.
y Exit trays that can be selected vary depending on whether the finisher is installed or not.
y The available exit tray may be restricted depending on copy modes and paper sizes.
y Exit tray selection is set at automatic selection by default.
Changing the exit tray
The exit tray currently selected is displayed on the equipment status indication area. To change the exit tray, press [EXIT
TRAY]. The display changes every time you press this from the exit trays of the equipment, those of the Finisher (optional)
and automatic selection in order.
Current exit tray
Exit tray auto-selection
indication
[
EXIT TRAY
]
button
To Next Page
Loading...
