Toshiba e-studio 5560c - Selecting Finishing Mode; Finishing Modes and Optional Finishing Devices

3 BASIC COPY MODES
66 Selecting Finishing Mode
Selecting Finishing Mode
 Finishing modes and optional finishing devices
See the table below for each finishing mode.
The available finishing modes differ depending on the type of optional finishing devices (Finisher and Hole Punch Unit)
installed. Finishing devices available for this equipment are as follows:
Finisher
y Finisher MJ-1103
y Saddle Stitch Finisher MJ-1104
Hole Punch Unit
Hole Punch Unit MJ-6102
Check the finishing modes enabled with each finishing device.
Finishing mode Description
Non-sort Non-staple Copies exit without being sorted or stapled.
Sort ( P.68) Copies exit in the same page order as the originals one set after another.
Group ( P.68) Copies grouped by page exit.
Rotate sort ( P.69) Copies exit set by set alternately in a different direction.
Staple sort ( P.70) Copies exit with their corner stapled.
Magazine sort ( P.72) Copies exit in a book-type page order.
Center fold ( P.72) Copies exit in a book-type page order with their center folded.
Saddle stitch ( P.72) Copies exit in a book-type page order with their center folded and stapled.
Magazine sort & center fold
( P.72)
Magazine sort and center fold are used together.
Magazine sort & saddle stitch
( P.72)
Magazine sort and saddle stitch are used together.
Hole punch ( P.75) Copies exit with their side punched.
Manual staple ( P.76) Copies are stapled manually.
Finishing mode
Devices
MJ-1103 &
MJ-6102
MJ-1103
MJ-1104 &
MJ-6102
MJ-1104 No device
Non-sort Non-staple Yes Yes Yes Yes Yes
Sort Yes Yes Yes Yes Yes
Group Yes Yes Yes Yes Yes
Rotate sort Yes Yes Yes Yes Yes
Staple sort Yes Yes Yes Yes —
Magazine sort Yes Yes Yes Yes Yes
Center fold — — Yes Yes —
Saddle stitch — — Yes Yes —
Magazine sort & center fold — — Yes Yes —
Magazine sort & saddle stitch — — Yes Yes —
Hole punch Yes — Yes — —
Manual staple Yes Yes Yes Yes —