1.BEFORE USING EQUIPMENT
Placing Paper 17
1 BEFORE USING EQUIPMENT
3
Select the paper size on the touch panel.
1) Select the drawer in which you placed paper.
2) Select the paper size.
3) Press [OK].
To automatically detect the size of paper placed in a drawer:
Select [AUTO (mm)] when A/B format paper is placed and [AUTO (inch)] when LT format paper is placed instead of
selecting a specified paper size. The paper size is automatically registered to the equipment with the automatic
paper size detection function when paper is placed in this drawer.
4
Press [CLOSE] on the touch panel or the [USER FUNCTIONS] button on the control
panel.
Setting paper type
When you place any special paper other than plain paper or that not used for normal copying, you need to set the
thickness and attribute into this equipment.
y The thickness and attribute can be set together.
y When the thickness “THICK 1, 2 or 3”, or an attribute other than “NONE” is set for a drawer, the paper placed in this
drawer will not be used for the automatic paper selection mode.
y When an attribute other than “NONE” is set for a drawer, the Automatic Change of Paper Source function (Feeding
the same size of paper from a different drawer even if the specified drawer from which paper is being fed is empty)
is disabled for the paper in this drawer.
For how to set Automatic Change of Paper Source, refer to the MFP Management Guide.
y The set paper type appears on the equipment status indication area with an icon.
P.10 “Equipment status indication area”
Acceptable paper types are as follows:
To Next Page
Loading...
