Setting up from TopAccess 123
6
Click [OK] to apply the changes.
y This equipment starts initializing the network interface card to apply the changes
During the initialization of the network interface card, the network will not be available.
TopAccess will display “Please restart after waiting a few minutes.” During the initializa-
tion, the Touch Panel Display will display “NETWORK INITIALIZING”. When this mes-
sage disappears, TopAccess will once again be available.
Setting up the TCP/IP
You can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be
configured to enable TopAccess, SMB printing, Raw TCP or LPR printing, IPP printing, Save as
file to network folder, Scan to Email, and Internet Fax.
1) Ethernet Speed Duplex Mode
Select the ethernet speed.
1
2
3
4
5
6
7
8
9
10
11
12
To Next Page
Loading...
