e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 10
[B] Drum cleaner unit
(1) Take out the process unit.
" P.11-9 "[A] Process unit"
(2) Disconnect 2 connectors and remove 2
screws.
(3) Release 1 latch. Then pull out the process
unit front cover and take it off.
Note:
When installing the process unit front cover,
wire the harness correctly in order not to con-
tact the gears and harness of the process
unit front cover each other.
Fig. 11-8
Fig. 11-9
Fig. 11-10
Process unit front cover Connector
Connector
Latch
for MJD
Process unit front cover Connector
Connector
Latch
except for MJD
Process unit
front cover
Harness
07/03
To Next Page
Loading...
