5/6
Position of Certification label, etc.
Identification label
Explanatory label
Warning label
Warning for high-temperature areas (fuser unit)
Warning for high-temperature areas (ventilation holes)
For EU
For the U.S.A. and Canada
Certification label
(
For the U.S.A. and Canada
)
Other points
• Do not turn the power OFF with jammed paper left inside the equipment. This could cause malfunctions when the main switch
is turned ON next time.
• Be sure to turn the power OFF when leaving the office or if there is a power failure.
• Be careful because the paper exit area and paper just after exiting are hot.
• Do not place anything other than paper on the receiving tray. This could disturb a normal operation and cause malfunctions.
• Do not touch the photoconductive drum surface or the transfer charger. This could cause image problems.
• Do not open/close the covers and the bypass tray, or pull out the drawers during printing.
To Next Page
Loading...
