Toshiba E-STUDIO2000AC - Bridge Kit; Finisher and Hole Punch Unit

1.TROUBLESHOOTING FOR THE HARDWARE
42 Clearing a Paper Misfeed
 Bridge Kit
1
Open the cover holding the handle of the Bridge Kit.
2
Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right side is caught by the fuser unit, follow the steps on 
P.36 “Fuser unit”.
3
Close the Bridge Kit cover.
 Finisher and Hole Punch Unit
Paper misfeed in the upper receiving tray
1
Raise the lever and open the upper receiving tray of the finisher.
2
Remove the misfed paper.