Toshiba E-STUDIO2000AC - Clearing Paper Misfeeds Caused by a Wrong Paper Size Setting

1.TROUBLESHOOTING FOR THE HARDWARE
60 Clearing a Paper Misfeed
13
Carefully return the finisher to its original position.
Do not put your hand or fingers on the top of the finisher when closing it.
They could be caught and this could injure you.
14
Close the front cover of the finisher.
 Clearing paper misfeeds caused by a wrong paper size setting
Paper misfeeds occur when there is a mismatch between the size of the paper in a drawer or the bypass tray and the
size registered for the corresponding drawer or the bypass tray in the equipment. The message “Check paper size
setting on control panel for drawer N. Check the direction or size of the paper.” or “Check paper size setting on control
panel for Bypass. Check the direction or size of the paper.” appears on the touch panel.
In this case, just clearing the misfed paper does not prevent another paper from being misfed. Be sure to follow the
procedure below.
Troubleshooting differs depending on how the paper misfeed has occurred:
 P.61 “Misfeed when making copies or prints (using a drawer)”
 P.63 “Misfeed when making copies or prints (using the bypass tray)”
 P.64 “Misfeed when printing from the Fax”