1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 49
TROUBLESHOOTING FOR THE HARDWARE
5
Open the cover holding the handle of the Bridge Unit.
6
Remove the misfed paper inside the Bridge Unit.
7
If the paper size is small, turn the knob shown in the following figures to send the paper, and then
remove the misfed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same time.
Be sure to turn the knob to the direction indicated by the arrow to remove the misfed paper. If you pull out the
paper forcibly without turning the knob, this may tear the paper.
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
To Next Page
Loading...
