Chapter 5 MAINTENANCE & SPECIFICATIONS
64
We recommend you to clean the following items weekly, so that the originals can be scanned in unsoiled conditions.
Be careful not to scratch the parts that you are cleaning.
Daily Inspection
The cleaning method for the equipment is as follows.
1. Scanning area (surface of the long rectangular glass)
Wipe it with a soft dry cloth. If there are still stains remaining, wipe clean with a piece of soft cloth which has been moistened
with water and then squeezed well.
Do not use solvents such as alcohol.
2. Original glass
3. Guide
4. Platen sheet
Clean the surface as follows depending on the staining.
• Clean it with a soft cloth.
• Clean it with a soft cloth lightly moistened with water.
• Clean it with a soft cloth lightly moistened with alcohol, and then wipe it with a dry cloth.
• Clean it with a soft cloth lightly moistened with watered-down neutral detergent, and then wipe it with a dry cloth.
Notes
Be careful not to scratch the portions in cleaning.
Do not use such solvents as thinner or alcohol when cleaning the surface of the equipment.
This could warp the shape of the surface or leave it discolored.
When using a chemical cleaning pad to clean it, follow the instruction.
•
•
-
-
To Next Page
Loading...
Need help?
General
