2.WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
106 When You Think Something Is Wrong With the Equipment
Sheets are not aligned
when exiting.
Sheets are not placed in the
drawer with correct side up for
this equipment.
Check the printing side of the sheets and place
them correctly. Information about the printing side
may be given on the wrapping paper of the sheets.
If you cannot find which side is the printing side, try
printing on both sides to see if the sheets are
aligned when exiting.
The type of paper
corresponding to that being
used has not been set.
Check that the set paper type corresponds to the
paper in use.
For details, refer to Chapter 1 of the Paper
Preparation Guide.
The message indicating no
paper does not disappear
even after paper is placed in
the drawer.
Sheets placed in the drawer are
not aligned.
Remove the sheets from the drawer, align them,
and replace them.
The side and end guides do not
match the paper size in the
drawer.
Adjust the side and end guides to match the paper
size.
The amount of paper placed in
the Large Capacity Feeder is too
small.
Place more than 10 sheets of paper in the Large
Capacity Feeder.
The paper is misfed at the end
of the drawer.
Pull out the drawer and remove any misfed paper.
There is something other than
paper in the drawer.
Do not put anything but paper in the drawer.
Problem Description Cause Corrective Action
To Next Page
Loading...
