2.WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
When You Think Something Is Wrong With the Equipment 51
WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
Originals and paper
The window “Enter the user
name and Password”
appears.
The equipment is managed
under the user management
function.
Enter your user name and password. If you do not
know them, contact the administrator of the
equipment.
A message is displayed on
the touch panel.
Some trouble occurred in the
equipment (or the message is
displayed just for an ordinary
operation).
See the meaning of the message referring to the
listing below.
P.11 “Messages Displayed on the Touch Panel”
The equipment reboots
automatically.
The auto-recovery function
works because a memory or
operation abnormality has been
detected.
Due to rebooting, the equipment has been
recovered to the normal condition. You can
operate the equipment as usual.
The power of this
equipment has been turned
OFF.
The equipment has
automatically been turned OFF
by means of the sleep mode
feature.
To prevent this, change the setting of the sleep
mode to [Sleep].
The stapler does not work
even if an original is set in
the offline stapler.
The front cover of the
equipment or the automatic
duplexing unit cover has been
opened.
Close the cover opened.
The equipment is in the Sleep
mode.
Press the [ENERGY SAVER] button to clear the Sleep
mode.
Refer to Chapter 1 of the Quick Start Guide.
The equipment is in the Super
Sleep mode.
Press the [ENERGY SAVER] button to clear the
Super Sleep mode.
Refer to Chapter 1 of the Quick Start Guide.
Problem Description Cause Corrective Action
The original is misfed. The original is unsuited for the
equipment.
Check whether the original is suitable for the
equipment.
For details, refer to Chapter 2 of the Paper
Preparation Guide.
Problem Description Cause Corrective Action
To Next Page
Loading...
