Installing the Printer on Mac OS X 10.2.4 to Mac OS X 10.4.x 145
- Device: Internet Printing Protocol (https)
- Device Name: <Any Name>
- Device URI: https://<IP address>:443/Print
- Printer Model: TOSHIBA
- PPD: TOSHIBA e-ST450/453 Series PS (or UK PS)
TOSHIBA e-ST280/283 Series PS (or UK PS)
4
Click [Add].
y The Installable Options window appears.
5
Set the following options.
y Finisher
Not Installed — Select this if a finisher is not installed.
Single-Position Stapler — Select this when the Hanging Finisher is installed.
Multi-Position Stapler — Select this when the Finisher or Saddle Stitch Finisher is
installed.
Multi-Position Stapler and Hole Punch — Select this when the Finisher or Saddle
Stitch Finisher and Hole Punch unit are installed.
Job Separator — Select this when the Job Separator is installed.
Offset Stacker — Select this when the Offset Stacker is installed.
y Drawers
For e-STUDIO452 Series and e-STUDIO453 Series:
Not Installed — Select this when no optional drawer is installed.
Drawer 3 — Select this when the drawer 3 is installed.
Drawer 3 and 4 — Select this when the drawer 3 and 4 are installed.
LCF — Select this when the LCF is installed.
For e-STUDIO282 Series and e-STUDIO283 Series:
Drawer 1 — Select this when the Drawer 1 is installed.
Drawer 1 & LCF — Select this when the Drawer 1 and LCF are installed.
Drawer 1 & 3 — Select this when the Drawer 1 and Drawer 3 are installed.
Drawer 1,3 & 4 — Select this when the Drawer 1, Drawer 3 and Drawer 4 are installed.
Drawer 1 & 2 — Select this when the Drawer 1 and Drawer 2 are installed.
Drawer 1,2 & LCF — Select this when the Drawer 1, Drawer 2 and LCF are installed.
Drawer 1,2 & 3 — Select this when the Drawer 1, Drawer 2 and Drawer 3 are installed.
Drawer 1,2,3 & 4 — Select this when the Drawer 1, Drawer2, Drawer 3 and Drawer 4 are
installed.
To Next Page
Loading...
