Before Using the Printer Driver 201
1
Select the printer driver in the Printers and Faxes folder. Then click
[File] and select [Properties].
y When you are operating under Windows 98/Me/NT 4.0/2000, open the Printers folder
to access the printer driver.
y When using Windows Vista, click [Start], select [Control Panel], and click [Printer]
under [Hardware and Sound] to open the Printers folder.
y The printer driver properties dialog box appears.
2
Display the [Configuration] tab, check off the “Enable SNMP Com-
munication” option, and set the following options.
Model Selection — This sets the model type of the equipment.
Automatic Duplexing Unit — This sets whether or not optional automatic duplexing unit
is installed. (For e-STUDIO282 Series and e-STUDIO283 Series Only)
Drawer — This sets whether the drawers or LCF (not available for some countries or
regions) are installed.
Finisher — This sets whether or not optional finisher is installed.
Hole Punch Unit — This sets whether or not optional hole punch unit is installed.
Memory — Select the size of memory installed.
LCF is not available for some countries or regions.
For more information about each item, see descriptions about the Configuration Tab.
To Next Page
Loading...
