Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x 291
— Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1) Destination
This selects the destination tray.
- Auto — Select this to route the output to the default tray (that is set as the default tray for
raw job in the Printer setting page of TopAccess Administrator’s page).
- Inner Tray — Select this to route the output to the inner tray.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
- Job Separator Upper — Select this to route the output to the upper tray of the Job Sep-
arator.
- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
y Depending on the type of finisher installed and destination settings, stapling and hole
punching may not be performed.
y Depending on the equipment settings, the paper may be delivered to a tray that cannot
carry out stapling or hole punching when “Auto” is selected as the “Destination” option.
y For e-STUDIO452 Series and e-STUDIO453 Series, “Tray 1” and “Tray 2” can be
selected when the Hanging Finisher, Finisher (Type A), Finisher (Type B), or Saddle
Stitch Finisher are installed.
y When the Finisher (Type B) is installed in the e-STUDIO452 Series and stapling is
enabled, select “Tray 2”.
y For e-STUDIO282 Series and e-STUDIO283 Series, “Tray 1” and “Tray 2” can be
selected when the Hanging Finisher is installed, and “Tray 1” can be selected when the
Saddle Stitch Finisher is installed.
y When the optional Job Separator is installed, you can select “Job Separator Upper” and
“Job Separator Lower” instead of “Inner Tray”.
1
2
3
To Next Page
Loading...
