6.TEMPLATES
Registering Templates 139
6 TEMPLATES
7
Enter the necessary information about the template.
NAME 1 & 2: Enter the name of the template. NAME 1 appears above the template button and NAME 2 appears
below. Be sure to enter at least one of them. When you press either of them, the on-screen keyboard appears.
Enter within 11 letters.
The symbols below cannot be used.
; : / \ " = | * < > ? + [ ] , .
USER NAME: Enter the name of the template owner as required. When you press it, the on-screen keyboard
appears. Enter within 30 letters.
PASSWORD: Key in a password here, if you want to require a password to recall the template. When you press it,
the on-screen keyboard appears. Key in following the procedure below.
1) Press [PASSWORD], and then key in a 5-digit password.
The letters keyed in appear as asterisks (*).
2) Press [RETYPE PASSWORD], and then key in the password again.
3) Press [OK].
Press the [CLEAR] button on the control panel to delete the letter keyed in.
AUTOMATIC START: Press [ENABLE] if you want the operation of set functions to start immediately after pressing
a button for the corresponding template. Press [DISABLE] if you do not want it to start until you press the
[START] button on the control panel.
To Next Page
Loading...
