Note
• If the inner finisher is installed, be sure to remove any
output paper on it before opening the top cover.
4
Remove the print cartridge and place it on a
flat surface.
5
Cover the print cartridge with paper so that
it will not be exposed to light.
6
Remove the jammed paper remaining
inside of the unit.
7
Hold the fuser unit handle and lift the fuser
unit out of the machine.
8
Tilt the release levers on the fuser unit
forward, and be sure to pull out the jammed
paper forward gently.
9
Hold the fuser unit handle and return the
fuser unit into its original position.
10
Return the print cartridge into the machine
carefully.
To Next Page
Loading...
