Toshiba e-STUDIO5018A - Installing the license

13
TABLE 1 - Correspondence table when NG occurs
No.
Inspection item
Inspection result
Correspondence
01
Board Type
NG
Replace the SYS board.
02
CPU Clock
NG
Replace the SYS board.
03
FROM
NG
Replace the SYS board.
04
Main Memory
Size
NG
NG <2GB>
NG <4GB>
Step 1.Check the installation status of the
Main memory and reinstall it if necessary.
Step 2. Perform calibration of the Main
memory at the time of startup.
Step 3. Replace the Main memory.
Step 4. Replace the SYS Board.
05
Main Memory
R/W
NG
Step 1. Check the installation status of the
Main memory and reinstall it if necessary.
Step 2. Perform calibration of the Main
memory at the time of startup.
Step 3. Replace the Main memory
Step 4. Replace the SYS board.
06
FRAM R/W
NG
Step 1. Check the installation status of
the SRAM (FRAM) and reinstall it if
necessary.
Step 2. Replace the SRAM (FRAM)
Step 3. Replace the SYS board.
07
RTC
NG
Replace the SYS board.
08
PCIE ASIC0
NG
Replace the SYS board.
09
PCIE ASIC1
OK?
[Not detected]
Check only machine installed the
DSDF unit
Step 1. Check the installation status of
the DSDF I/F board and reinstall it if
necessary.
Step 2. Replace the DSDF I/F board.
Step 3. Replace the SYS board.
10
NIC PCIE
NG [NIC VER]
Step 1. Update NIC Firmware.
Step 2. Replace the SYS board.
NG
Replace the SYS board.
11
Network
NG [MAC_I2C]
Replace the SYS board.
NG [MAC_NIC]
Replace the SYS board.
NG [MAC_I2C]
[MAC_NIC]
Replace the SYS board.