1.TROUBLESHOOTING FOR THE HARDWARE
34 Clearing a Paper Misfeed
3
Raise the lever and open the upper receiving tray of the finisher.
4
Turn the green knob shown in the following figures to send the paper, and then remove the
misfed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same time.
Be sure to turn the knob to the direction indicated by the arrow to remove the misfed paper. If you pull out the
paper forcibly without turning the knob, this may tear the paper.
5
Remove the misfed paper from the right or left side.
6
Remove the paper misfed in the equipment side.
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
To Next Page
Loading...
