108 Troubleshooting for the Hardware
0.Troubleshooting for the Hardware
Messages Displayed on the Touch Panel
A message appears on the upper part of the screen to notify users of a problem, etc. The major examples of problems
and how to solve them are described in the table below.
Clearing a Paper Misfeed
Right side of the equipment (e-STUDIO7506AC Series, e-STUDIO8508A Series)
Do not touch the fuser unit or the metal portion around it.
Since they are very hot, you could be burned or the shock could cause you to injure your hand in the machine.
Fuser unit
1
Pushing the lock lever, pull out the duplexing unit from the equipment until it stops.
Be careful not to touch the slide rails (A in the figure).
This could injure you.
2
Open the transport guide holding the green knob and then release the misfed paper.
Message Problem Description Corrective Action
Ready (Check Stapler) Staple jam has occurred in the
stapler of the finisher or the
staple sheet has not been fed
sufficiently.
Remove the top staple sheet.
To Next Page
Loading...
