6.User Functions
36 Admin
4
Press [Yes].
Do not remove the USB storage device until the data transfer is complete. Removing the device while data are
being transferred could destroy them or cause a malfunction of the equipment.
5
When the installation is complete, press [OK].
If the installation fails, the message “The installation failed. Do you want to retry?” will be displayed on the
Caution screen. In this case, press [Yes] to perform the installation again.
6
Remove the USB storage device from the USB port on the equipment.
After the installation is complete, it is necessary to reboot the equipment. When the message “Reboot the
machine” is displayed on the touch panel, turn the power of the equipment OFF and then back ON by using the
[POWER] button on the control panel.
To Next Page
Loading...
