Connecting an audio system
Back panel of TV
You will need:
,, one set of standard audio cables
Amplifier
Connecting an AV amplifier with built=in digital surround
This connection allows you to use an audio amplifier with built-in
digital surround and external speakers.
Note:
To hear sound when using an external audio ampfifier, the
volume of both the TV and the amplifier must be set
above 0 (zero.)
For example, if the volume of the TV is set to O,you will
not be able to hear any sound, even the volume of the
amplifier is at its highest level.
You will need:
,, one coaxial digital cable
,, Six sets of standard audio cables
TV
AV Amplifier with built-in digital surround
ll
TV Subwoofer Front
. ; / Speaker
Front--__ --_ [ \ / (Right)
Speaker_ ___ .__?
(Left)
_ Surround Speaker _ Surround
(Left) ---'1-- Speaker (Right)
Coaxial digital audio out jack outputs only digital broadcast sound. Connect the Audio L/R jacks at the same time to listen to an
analog broadcast sound. In this case, the sound becomes analog.
13
J3W20221A(E) P07-13 13 20/12/2005,10:48 AM
To Next Page
Loading...
