Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCRs, and DVD players together, even if
they are different brands. If you will be using your TV with a Toshiba
satellite receiver, VCR, or DVD player, your remote control is already
programmed and ready to use. If you own different brands of cable TV
converters/satellite receivers, VCRs, and/or DVD players, you must
first program your remote control. (See "Programming the
remote control to operate your other devices," on page 15.)
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual suppfied with
your other devices to see which features may
be available. Additionally, the remote control
for this TV may not support certain features
available on the original remote controls for
your other devices, in which case it is
suggested that you use the original remote
control for the appficable device.
Caution:
* Never throw batteries into a fire.
2. Install two "AAA" size batteries. Match the + and - signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
Using the remote control to operate your
Notes:
, Be sure to useAAA size batteries.
, Disposeof batteries in a designated disposalarea.
* Batteriesshouldalways be disposedof with the
environmentin mind.Always disposeofbatteries in
accordancewith applicablelaws and regulations.
, If the remote control does not operate correctly,
or if the operating range becomes reduced,
replace batteries with new ones.
, When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
* Alwaysremovethebatteriesfromtheremotecontrol
if theyare deadorif the remotecontrolis not tobe
used foran extendedperiodof time.Thiswill
preventbatteryacidfrombaking into thebattery
compartmenL
other devices
To control a cable TV Power
converter/satellite Input(TV) --
receiver: Mute (TV) --
Channel
Program the remote Numbers --
control to recognize the CH RTN
brand of your cable TV (ChannelReturn)--
converter/satellite receiver Channel/\ v --
(see "Programming the CBL/SAT --
remote control to operate Volume +/- (TV) --
your other devices" on Pic Size (TV) --
page 15.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
TV/VCR --
!iiiiiiiii ii!i
i i!ii!i i!ii!i
ii;ii!!!i!i ii!_iii
To control a VCR:
Program the remote Input (TV)
Power
control to recognize Channel
the brand of your VCR Numbers
(see "Programming the
CH RTN
remote control to (ChannelReturn)
operate your other VCR
devices" on page 15.) Channel/\v
The buttons shown at Volume +/- (TV)
right will then control Pic Size (TV)
the VCR.
Press "VCR" first.
VCR controls
14
J3W20221A(E) P14-21 14 20/12/2005,10:48 AM
To Next Page
Loading...
