G9000 1000kVA OPTIONAL BYPASS FUSE Installation Guide – 92932-001 1
1 OVERVIEW
Your TOSHIBA Uninterruptible Power Supply System (UPS) can be equipped with bypass fuses to
prevent an overcurrent from keeping flowing through UPS and the peripheral cabinet in case the
short-circuited load is fed by bypass supply.
Removable conductors in bypass cabinet can be replaced with the optional bypass fuses. This document
describes the installation procedures.
Lethal voltages exist within the equipment during operation. Observe all warning and
cautions listed in the manual. Failure to comply may result in serious injury or death.
Obtain qualified service for this equipment as instructed.
Ensure the UPS and bypass circuits are de-energized and disconnected from the
utility source before opening the access panels to install the bypass fuses.
2 PARTS LIST
Table.1 Parts List
To Next Page
Loading...
