47
English
CONTROLS AND FEATURES
NOTE:
• When the DHCP function of the router connected with
this TV is On, you can set Auto Setup to On or Off.
(This should usually be set to On.)
• When the DHCP function of the router is Off, set Auto
Setup to Off, and set the IP Address manually.
IP Address Setup
Auto Setup
a In the Network menu, press B / b to select
Network Setup and press OK.
b Press B / b to select Advanced Network Setup
and press OK.
c Press B / b to select IP Address Setup and
press OK.
d Highlight Auto Setup and press c and B / b to
select On.
NOTE: Other items will be greyed out when Auto Setup
is set to On.
Manual Setup
a In the Network menu, press B / b to select
Network Setup and press OK.
b Press B / b to select Advanced Network Setup
and press OK.
c Press B / b to select IP Address Setup and
press OK.
d Highlight Auto Setup and press c and B / b to
select Off.
e Press B / b to select IP Address.
f Press C / c to highlight the field you want to
change, and then use the number buttons to input
the IP address. To save the setting, press OK.
NOTE: IP address field numbers must be between
0 and 255. After each field number has been set,
press OK to store the entire address. If the entire
IP Address is invalid, a warning message will
appear after OK is pressed.
g Press B / b to select Subnet Mask, and edit in
the same way as IP Address.
h Press B / b to select Default Gateway, and edit
in the same way as IP Address.
NOTE: If you manually set the IP address, you must not
use the same IP address for any other device. The IP
address you use should be a private address.
Advanced Network Setup
To Next Page
Loading...
