To Next PageTo Next Page
Need help?Do you have a question about the Toshiba MMK-AP0243H and is the answer not in the manual?
General| Brand | Toshiba |
|---|---|
| Model | MMK-AP0243H |
| Category | Air Conditioner |
| Language | English |
Lists components included with the indoor unit for installation and operation.
Ensure compliance with regulations, read precautions, trial operation, turn off power for maintenance.
Covers professional installation, grounding, electrical work, refrigerant piping, secure mounting, and leak safety.
R410A characteristics, precautions for water, dust, oil entry, and use of exclusive tools.
Requirements for power supply disconnection and proper flare nut tightening to prevent leaks.
Wear heavy gloves and long sleeve shirt during installation work to avoid injury.
Install horizontally, ensure servicing space, and ensure drain water causes no problem.
Avoid areas with salt/sulfide gas, kitchens, organic solvents, high frequency, noise, or poor ventilation.
Ensure secure mounting to withstand weight; perform installation to guard against wind/earthquake.
Optimal placement for signal reception, avoiding obstacles, direct sunlight, and heating sources.
Select place for even air circulation; avoid areas marked "NO GOOD".
Instructions for drilling a hole for refrigerant pipes, specifying diameter based on model.
Securely fix the plate to the wall using screws, ensuring it is horizontal.
Use 6 mounting screws for corners and lower parts; use appropriate anchors for concrete walls.
Apply heat-insulation to pipes and hoses to prevent dew generation.
Steps to remove the front panel and cut slits for piping connections.
Instructions for removing, installing, and securing the drain hose.
Procedures for installing the drain cap and routing the drain hose securely.
Binding auxiliary pipes and wiring, arranging pipes, and insulating connecting pipes.
Pass pipes through the hole and hook the unit onto upper and lower parts of the installation plate.
Use screws to fix the unit to the installation plate if the lower part floats due to piping.
Run drain hose sloped downwards, ensure water drains outdoors, and arrange pipe for proper drainage.
Use specified copper pipe thickness and flare nut/flare works suitable for R410A.
Remove dust/moisture, ensure tight connections, evacuate air, check leaks, and follow flaring procedures.
Specifies tightening torque for flare pipe connections to prevent leaks and nut cracking.
Insulate pipes to prevent condensation and perform airtight test/gas leak check.
Covers wiring safety, grounding, regulations, and general installation requirements.
Details power, control, and remote controller wiring specs; notes on proximity and insulation.
Step-by-step guide for connecting power supply and control wiring to the indoor unit.
Instructions for connecting power supply and communication wires for the flow selector unit.
A wired remote controller is necessary for this function; wireless is unavailable.
Explains initial delay and basic procedure for changing settings using the remote controller.
How to change filter sign lighting time and adjust detection temperature for heating.
How to adjust air direction and control multiple units in a group.
Perform checks like resistance measurement and outdoor unit valve status before starting.
Step-by-step procedures for executing test runs with wired and wireless remote controllers.
Details on initiating forced cooling operation and how to stop a test run.
How check codes appear and procedure to confirm stored trouble history.
Explains how to check operation status using remote controller or outdoor unit displays.
A comprehensive list of check codes, their names, judging devices, and detailed explanations.
Specific error codes and descriptions for TCC-LINK central control devices.
