Toshiba MMY-MAP0806HT8P-E - Carrying in the Outdoor Unit

116-EN115-EN
– 58 –
5 Carrying in the outdoor unit
CAUTION
Handle the outdoor unit carefully, observing the following items.
• When using a forklift or other machinery for loading/unloading in transportation, insert the fork of the forklift into
the rectangular holes for handling as shown below.
• When lifting up the unit, insert a rope able to bear the unit’s weight into the rectangular holes for handling, and
tie the unit from 4 sides.
(Apply padding in positions where the rope comes into contact with the outdoor unit so that no damage is
caused to the outer surface of the outdoor unit.)
(There are reinforcing plates on the side surfaces, so the rope cannot be passed through.)
NO GOOD NO GOODGOOD
Rope
Plaster
board
Plaster
board
Rectangular
holes for
lifting
Reinforcing
plate
NO GOOD
Fork of the
forklift
GOOD
Rectangular
holes for
handling
Front/Back
Side
 Weight centre and weight
¿ Weight centre of an outdoor unit
700
755
Y
920
755
Y
Z
Z
X
XX
Z
1310
755
Y
Anchor bolt positionA. B. C.Anchor bolt position Anchor bolt position
Anchor bolt position Anchor bolt position Anchor bolt position
(Unit : mm)
No. Model type X (mm) Y (mm) Z (mm)
Weight (kg)
Heat pump model Cooling only model
A
MMY-MAP080*
510 355 600 242 241MMY-MAP100*
MMY-MAP120*
B
MMY-MAP140*
595 360 690 300 299
MMY-MAP160*
C
MMY-MAP180*
790 360 710 371 370MMY-MAP200*
MMY-MAP220*
1117101201-3 EN.indd 581117101201-3 EN.indd 58 8/8/2559 BE 3:49 PM8/8/2559 BE 3:49 PM