■
Floor standing cabinet type
▼ When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼ When heating (for heat-pump model only)
Move the louver manually and point it downward to
send heated air to the fl oor.
Clean the air fi lter often
• A clogged air fi lter lowers the cooling/heating
performance.
Do not cool/heat too much
WARNING
Do not expose your body to cool air directly for a
long time and do not cool yourself excessively.
Doing so may result in deteriorated physical condition
and ill health.
• Cooling/Heating too much is bad for your health. In
particular, take care with handicapped/old people
and children.
Close windows and doors
• Do not let cooled/heated air escape from the room.
Cool/Heat the room evenly
• Adjust the air direction with the louver. Exposing
yourself to blowing air directly for a long time is bad
for your health.
To save energy and perform comfortable cooling and heating
Air conditioner operating conditions
For proper performance, operate the air conditioner under the following temperature conditions:
Cooling operation
Outdoor temperature : -5°C to 46°C (Dry-bulb temp.)
Room temperature : 21°C to 32°C (Dry-bulb temp.), 15°C to 24°C (Wet-bulb temp.)
[CAUTION]
Room relative humidity: less than 80 %. If the air conditioner operates in
excess of this fi gure, the surface of the air conditioner may cause dewing.
Heating operation
Outdoor temperature : -25°C* to 15.5°C (Wet-bulb temp.)
Room temperature : 15°C to 28°C (Dry-bulb temp.)
If air conditioner is used outside of the above conditions, safety protection may operate.
* Low ambient heating (-20°C or less) for extended periods of time is not allowed.
◆ Changing the air discharge
Follow the procedure below to change the air
discharge:
1
Remove the two fi xing screws of the air
discharge. (The fi xing screws are to be reused)
2
Insert your hand into the air discharge and pull
it up slightly, then remove the air discharge
from the claw hook at the rear side.
3
Lift up the air discharge and remove it.
4
Reverse the air discharge and reattach it to the
main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed fi xing screws so that it does not
come off.
9 Tips for saving energy and comfortable
performance
Check
periodically!
Do not cool
down too
much!
Close.
– 19 –
37-EN 38-EN
To Next Page
Loading...
