Toshiba MV13L3 - SERVICING FIXTURES AND TOOLS; PREPARATION FOR SERVICING

Taper nut driver
70909228
SERVICING FIXTURES AND TOOLS
Back tension cassette gauge
70909103
Torque cassette gauge
(KT-300NR)
70909199
Adapter
Dial Torque Gauge
(10~90gf•cm)
(60~600gf•cm)
JG154 Cable
VTR cleaning kit VTR lubrication kit Grease JG002B
JG002E
JG002F
JG153 X Value Adjustment
Screwdriver
JG022 Master Plane JG024A Reel Disk Height
Adjustment Jig
Alignment Tape
ST-N5
ST-NF
Remarks
Part No.Ref. No. Parts Name
JG002B
JG002E
JG002F
APJG002B00
APJG002E00
APJG002F00
Adapter
Dial Torque Gauge (10~90gf•cm)
Dial Torque Gauge (60~600gf•cm)
VSR Torque, Brake Torque (S Reel/T Reel Ass'y)
Brake Torque (T Reel Ass'y)
VSR Torque, Brake Torque (S Reel)
JG154 APJG154000 Cable Used to connect the test point of SERVICE and GROUND
APJG022000JG022 Master Plane Reel Disk Height Adjustment
JG024A APJG024A00 Reel Disk Height Adjustment Jig Reel Disk Height Adjustment
JG153 APJG153000 X Value Adjustment Screwdriver X Value Adjustment
Tentelometer
PREPARATION FOR SERVICING
How to use the Servicing Fixture
1.
2.
3.
4.
Unplug the connector CP353 and CP354, then remove the TV/VCR Block from the set.
Remove the Operation PCB from the set, then connect it with the Syscon PCB.
If necessary, connect CP353. (Front A/V Jack Input Terminal)
Short circuit between TP1001 and Ground with the cable JG154.
(Refer to MAJOR COMPONENTS LOCATION GUIDE)
The EOT, BOT and Reel Sensor do not work at this moment.
At that time, the STOP/EJECT button is available to insert and eject the Cassette Tape.