18
Connections
75 Ω coaxial cable
75 Ω coaxial cable
Warning:
When playing DTS-encoded discs (unit), excessive noise may be output from the analog stereo jacks. To avoid possible
damage to the audio system, you should take proper precautions when the ANALOG AUDIO OUT (L/R) jacks of the unit are
connected to an amplification system. To enjoy DTS Digital Surround™ playback, an external 5.1 channel DTS Digital
Surround™ decoder system must be connected to the BITSTREAM/PCM AUDIO OUT jack of the unit.
Connecting to an amplifier equipped with an MPEG2 audio decoder
MPEG2 sound
You can enjoy motion picture and live concert DVD video discs with dynamic realistic sound by connecting an amplifier equipped with
an MPEG2 audio decoder or MPEG2 audio processor.
Connecting to an amplifier equipped with a digital audio input
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifier equipped with a digital audio input and speaker
system (right and left front speakers).
Notes:
• DO NOT connect the BITSTREAM/PCM AUDIO OUT jack of the unit to the AC-3 RF input of a Dolby Digital Receiver. This
input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the BITSTREAM/PCM AUDIO OUT
jack of the unit.
• Connect the BITSTREAM/PCM AUDIO OUT jack of the unit to the “COAXIAL” input of a Receiver or Processor.
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the wall
outlet before making any connections.
• The output sound of the unit has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level.
Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the unit’s power cord. If you leave the amplifier power on, the
speakers may be damaged.
• Use DVD video discs encoded via
the MPEG2 recording system.
Amplifier equipped with an
MPEG2 audio decoder
To COAXIAL
type digital
audio input
Amplifier equipped with
a digital audio input
To COAXIAL
type digital
audio input
LINE 1 IN
VIDEO
AUDIO
L
(MONO)
R
VIDEO
AUDIO
L
R
OUT PUT
DIGITAL AUDIO
VHF/UHF
COAXIAL
LINE 1 IN
VIDEO
AUDIO
L
(MONO)
R
VIDEO
AUDIO
L
R
OUT PUT
DIGITAL AUDIO
VHF/UHF
COAXIAL
5F10101C (E)p16-18 7:5:03, 18:5618
To Next Page
Loading...
