Toshiba MW24FP1 - Sound Control and SAP

und control a ustment/
Stereo and Seeond Audio Program (SAP)
Sound controls are factory preset but you can adjust them individually as follows:
The unit is equipped with a feature known as multi=channel YV sound or MTS.
MTS broadcasts greatly enhance TV viewing by bringing you programs with high
fidelity stereo sound.
MTS also provides an extra channel called the Second Audio Program or SAP
which broadcasters can use to transmit a second language for bilingual transmis=
sion or for other purposes.
S _ii, a:_'< , ii;
a>.......... AUDIO SELECT
...... CANCEL
ENU
÷
Press MENU, then press <_ or "_ to select []
option.
MENU i!i!i iiii i ii:ii i! ili iiiili iiii!!
iii_-_iiiiiiiiiii_iii!iiiiii_iiiiiiiiiiiiiiiiiiiiiiiii!iiiiiii_ii_iill
SETUP
Press _ or _ to select "AUDIO", then press "_.
Press _ or _ to select the item you want to
adjust, then press _ or "_ to adjust the
setting.
BASS:
TREBLE:
BALANCE:
SURROUND:
ON:
OFF:
STABLE SOUND:
ON:
OFF:
SAP :
ON:
OFF:
Press _ or "_ to ad _st the bass sound
Press _ or '_ to ad Jst the treble sound
Press _ or '_ to obtain an equal sound level
from both speakers.
Press _ or _ to select "ON" or "OFF".
The dynamic presence and sound created offers
a thoroughly enjoyable listening experience
Normal sound
Press _ or '_ to select "ON" or "OFF".
The Stable Sound feature limits the highest
volume level to prevent extreme changes in
volume when the signal source is changed
Normal sound
Press <_ or '_ to select "ON" or "OFF".
SAP is available.
SAP is not available.
After your desired setting press MENU
repeatedly until the menu screen is cleared.
MENU
SETUP
[] To return BASStTREBLEfBALANCE contro_ adjustments
to the factory preset _eve_s
Press CANCEL while making sound adjustments.
5L 0261C [Elp27-32 32
÷
When the TV is turned on or a channel se{ection is
made, make certain the "STEREO" appears on the
screen. This means that Stereo broadcasting is avail°
able. You can enjoy stereo sound from the _eft and
right speakers.
• When mono broadcasting is received, no indication is
displayed.
• if the broadcast signal is not strong enough or clear
stereo sound is not available, press AUDIO SELECT
to change to mono sound. The noise should be
eliminated. Press it again to return to the stereo sound.
-When the TV is turned on or a channel selection is
made, make certain the SAP appears on the screen.
This means that the Second Audio Program broad=
casting is available.
r o,0i31
[ STEREOSAP |
Press AUDIO SELECT to select the desired sound.
• AUDIO
SELECT
Broadcast
MONO
STEREO
MONO+SAP
STEREO+SAP
SAP setting
OFF
ON
OFF
ON
OFF
ON
OFF
ON
Audio display
MONO
MONO
STEREO---_MONO
STEREO*-_ MONO
MONO
SAP
STEREO---_MONO
SAP
20/4/04.16:06
÷