3
2
÷
The zero return function provides a convenient method of rap°
idly returning to the starting point of recording or playback. The
starting point can be indexed for any location on the tape by
pressing COUNTER RESET and ZERO RETURN.
Press DmSPLAY.
,,DISPLAY
0
Before playback or recording, press COUNTER
RESET to set the counter to "00:00:00".
COUNTER
RESET
ANGLE
Begin playback or recording.
CSRE
Press STOR
Press ZERO RETURN. The tape will rewind and
automatically stop at the "00:00:00" position.
ZERO
RETURN
SUBTITLE
[] Video head c_ogging
The video heads are the means by
which the unit reads the picture from the
tape during playback• tn the unlikely
event that the heads become dirty
enough to be ctogged, no picture will be
played back. This can easity be deter-
mined if, during playback of a known
good tape, there is good sound, but no
picture (picture is extremely snowy)• tf
this is the case, have the unit checked
by qualified service personnel.
Good Picture
Snowy Picture
[] Video head cleaning
Video head cleaning is needed when the playback picture
becomes unclear. This signifies that the heads are getting dirty
and can occur when playing poor quality or damaged tapes• tf
the heads require cleaning, use a equivalent high quality chemical
non-abrasive (wet) head cleaning tape or have them cteaned
professionally, tf playing a head cleaning tape in the unit once
does not improve the picture, play it several times before
requesting service•
Notes:
• DO NOT ATTEMPT TO CLEAN THE VIDEO HEADS OR
SERVICE THE UNIT BY REMOVING THE REAR COVER•
• Video heads may eventually wear out and should be replaced
when they fait to produce ctear pictures.
• To help prevent video head clogging, use only good quality
VHS tapes• Discard worn out tapes•
O
÷
37
5L00201C [E]p33-37 37 _ 20/4/04, 16:07
To Next Page
Loading...
