4 Replacement Procedures Error! Style not defined. Error! Style not defined.
3. Remove the touch pad bracket from the logic upper assembly.
Figure 4.34 Remove the touch pad bracket
Installing the Touch Pad board
Install the touch pad board according to the following procedures.
1. Seat the touch pad bracket in the correct position on the logic upper assembly.
2. Seat the touch pad board in the correct position. Secure the touch pad board to the logic
upper assembly with one M2x3 and two M2x4 screws.
3. Paste the mylar on the touch pad board.
4. Connect the cable to the touch pad.
NB300 Maintenance Manual 4-36
To Next Page
Loading...
