4.23 MDC 4 Replacement Procedures
4.23 MDC
Removing the MDC
The following describes the procedure for removing the MDC. (See Figure 4-39.)
1. Remove the following screws securing the MDC.
M2.04.0B BIND screw 2
2. Turn up the insulator.
3. Disconnect the MDC from the connector CN3010 on the system board.
4. Disconnect the MDC cable from the connector on the MDC.
M2.0x
4.0B BIND
MDC cable
MDC
CN3010
Modem jack
Insulator
Figure 4-39 Removing the MDC
PORTÉGÉ M780 Maintenance Manual (960-809) [CONFIDENTIAL] 4-63
Downloaded from LpManual.com Manuals
To Next Page
Loading...
