Toshiba Portege M780 - Base Assembly and Cover Assembly

4.14 Base assembly and Cover assembly 4 Replacement Procedures
4.14 Base assembly and Cover assembly
Removing the base assembly and cover assembly
The following describes the procedure for removing the base assembly and cover assembly.
(See Figure 4-24 to 4-26.)
1. Remove the following screw.
 M2.04.0B BIND screw 1
2. Disconnect the touch pad cable, LCD cable and digitizer cable from the connector
CN3250, CN5601, and CN9540 on the system board.
M2.04.0B BIND
Touch pad cable
(connected to CN3250)
LCD cable
(connected to CN5601)
Digitizer cable
(connected to CN9540)
Figure 4-24 Removing the base assembly and cover assembly (1)
PORTÉGÉ M780 Maintenance Manual (960-809) [CONFIDENTIAL] 4-41
Downloaded from LpManual.com Manuals