User’s Manual 4-7
Operating Basics
Removing the Reserve Pen case
To remove the Reserve Pen case, follow the steps as detailed below:
1. Save your work.
2. Turn the computer’s power off - ensure that the Power indicator is off.
3. Remove all cables and peripherals that are connected to the computer.
4. Close the display panel and turn the computer upside down.
5. Slide and then lift out the Reserve Pen case.
Figure 4-6 Removing the Reserve Pen case
■ A short and worn pen point is difficult to pull out. Replace the pen point
with a refill before it becomes too short to remove.
■ It is recommended that you keep another pen set as a spare. You can
buy replacement pen sets from your TOSHIBA authorized dealer.
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
Push lightly the point shown by the arrow using an object with a thin tip.
1. Reserve Pen case slot 2. Reserve Pen case
To Next Page
Loading...
