User’s Manual 3-37
Hardware, Utilities and Options
Installing the hard disk drive pack
To install the hard disk drive pack, follow the steps as detailed below:
1. Grasp the edges of the connector with one hand and the edges of the
hard disk drive pack with the other hand.
2. Connect the hard disk drive to the connector. Ensure they are
connected firmly. Please be careful not to pull the connector cables
when you install the hard disk drive pack.
3. With the connector connected, lower the hard disk driver down to the
storage position.
Figure 3-19 Installing the hard disk drive pack
4. Seat the cover and press down until the latches click into place.
5. Secure the cover with two screws.
6. Turn your computer over.
■ Be sure that you grasp the hard disk drive pack by its edges when you
remove/install the hard disk drive pack.
■ Do not pull the connector cables when you remove/install the hard disk
drive pack.
Never allow metal objects, such as screws, staples and paper clips, to
enter the computer. Foreign metal objects can create a short circuit, which
can cause computer damage and fire, possibly resulting in serious injury.
1. Hard disk drive pack 2. Connector
To Next Page
Loading...
