User’s Manual 4-33
Operating Basics
Using optical disc drives
The full-size drive provides high-performance execution of CD/DVD-ROM-
based programs. You can run either 12 cm (4.72") or 8 cm (3.15")
CD/DVDs without an adaptor. A Serial ATA interface controller is used for
CD/DVD-ROM operation. When the computer is accessing a CD/DVD-
ROM, an indicator on the drive glows.
If you have an Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II,
refer also to the Writing CD/DVDs on Ultra Slim Bay DVD Super Multi
(Double Layer) Drive Kit II section for precautions on writing to CDs/DVDs.
Loading discs
To load CD/DVDs, follow the steps as detailed below:
1. When the computer’s power is on, press the eject button to open the
disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
Figure 4-23 Pressing the eject button and pulling the disc tray open
Use the DVD playback application to view DVD-Video discs.
When the power of the optical disc drive is off, pressing the FN + Tab keys
will turn the power of the optical disc drive on. Furthermore, it is possible to
set it to turn the power of the optical disc drive on and eject the tray at the
same time.
1. Eject button 2. Disc tray
To Next Page
Loading...
